Technicolor TG650S, Руководство по установке и эксплуатации, Страница: 30 / 114

24
2 MANUAL INSTALLATION
DMS-CTC-20111123-0002 v1.0
2.5.1 Setting up a Mobile Interface
Procedure
To set up the mobile interface complete the following steps:
Step 1: Start a CLI session .
Step 2: Add a mobile interface
Step 3: Configure a mobile interface
Step 4: Attach the mobile interface
Step 1: Start a CLI session
For more information, see “3.3 The Command Line Interface (CLI)” on page 39 .
Step 2: Add a mobile interface
Execute the following command:
With the following parameters:

intf
The name of the mobile USB interface.
Example:
Step 3: Configure a mobile interface
Execute the following command:
With the following parameters:

intf
The name of the mobile USB interface.

pin
This parameter represents the PIN code of the SIM card.

puk
This parameter represents the PUK code of the SIM card.

apn
The Access Point Name (APN) used to access the packet switched services of the operator. The APN syntax must follow
the rules specified in the standard 3GPP23.003. It is recommended to always specify this value. If not specified, the
network will try to fill in the APN but may fail.
:mobile ifadd intf=<string>
:mobile ifadd intf=mobile_usb
With the command
mobile ifdelete intf
you can delete a mobile USB interface.
:mobile ifconfig intf=<string> [pin=<password>] [puk=<string>]
[apn=<string>] [mode=<{automatic|manual}>]
[operator=<number{0-99999}>] [technology=<{2G|3G}>]
[initcommand=<string>]
Only if you failed three times to attach the mobile interface using a wrong (unique) PIN code, the PUK code will
be used instead of the PIN code. It is advised to always fill in this parameter.