AC Power:
This fixture runs on 110 VAC, 50/60 Hz. Before powering on the unit, make sure the line voltage to which you
are connecting it is within the range of accepted voltages.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat (variable
resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0 to 100% switch.
To determine the power requirements for a particular fixture, see the label affixed to the back plate of the
fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its average
current draw under normal conditions.
Always connect the fixture to a circuit with a suitable electrical ground.
To connect the power cord to the LG46 plug the female side of the power cord into the power cord input which is on the
rear of the unit. Then plug the male side of the power cord to an electric outlet. When linking LG46 units to each other
connect the power output on the first unit to power input on the next unit.
The AC power cords supplied purposefully have 2 blades. If your outlet is not equipped to handle this type of plug, do not
attempt to forcefully plug this AC power cord into the outlet, and do not alter the plug so that it can fit in the outlet. Be
sure that the plug is well connected so that it does not disconnect in the middle of usage. If at any point in time the
supplied AC power cord is punctured or damaged replace it with a new power cord from a local electrician.
Technical Parameters:
LED Light
Red/Green/Blue
LED source:
46pcs*1W (Red:12 , Green:18 , Blue:16 )
Control Mode
Auto, Sound-Activated
Power Supply
AC110V
Power
10W
Product dimension
9.45
’’X4.7’’X4.7’’
LG46
