AC Power Cord Connection
To connect the power cord to your H12X500UBT simply plug female side of the power cord into the
power cord input which is on the rear of the unit. Then plug the male side of the power cord to an
electric outlet. The AC power cords supplied purposefully have 2 blades and one grounding prong. If
your outlet is not equipped to handle this type of plug, do not attempt to forcefully plug this AC power
cord into the outlet, and do not alter the plug so that it can fit in the outlet. The only course of action you
can take is to find another outlet which is properly equipped to handle a grounded plug or have an
electrician upgrade your electrical outlet. Be sure that the plug is well connected so that it does not
disconnect in the middle of usage. If at any point in time the supplied AC power cord is punctured or
damaged replace it with a new power cord from a local electrician.
NOTE: ONLY PLUG IN THE AC POWER CORD WHILE THE UNIT’S POWER IS OFF AND THE
VOLUME IS TURNED DOWN. TURNING ON THE UNIT WITH THE VOLUME TURNED UP MAY
CAUSE THE UNIT OR ANY SPEAKERS CONNECTED TO IT TO BE DAMAGED. ALWAYS TURN
DOWN THE VOLUME PRIOR TO TURNING OFF THE UNIT.
The H12X500UBT is designed to power up to six groups of full-range passive loudspeakers and two active
subwoofers. The speakers should be connected via the speaker wire outputs on the rear of the H12X500UBT.
Connecting the H12X500UBT to Passive Loudspeakers
Input / Output Connections
Connecting the Signal Source to the H12X500UBT(DVD/MIXER/MP3 etc.)
NOTE: BE SURE NOT TO CONNECT AN AMPLIFIER OR ANY AMPLIFIER SIGNAL INTO THE RCA
INPUT JACKS. AS THIS COULD DAMAGE THE H12X500UBT. NO OTHER AMPLIFIER IS NEEDED
TO POWER YOUR SIGNAL IN ADDITION TO THE H12X500UBT. ALWAYS MAKE SURE THAT
THERE IS ONLY ONE AMPLIFIER IN THE SIGNAL PATH.
There are also input jacks for a MP3 player, USB flash drive and SD card on the front panel of the
H12X500UBT which is compatible with iPod™(Classic and Nano) via the USB input. Just plug the MP3
player, USB flash driver, SD card or iPod™(Classic and Nano) into their respective input jacks and set
the H12X500UBT to the corresponding input. Be sure that the volume of your MP3 player and
H12X500UBT are turned down at first and then slowly raise the volume to prevent damaging the
speakers or any of your other equipment.
The unit has two RCA input jacks on the rear of the unit which is designed to receive the signal directly
from your CD,mixer or any of your other sources.To ensure that you have correctly connected your CD
player (other sound sources) to the unit, make sure that the CD player has a RCA cord coming from its
output and that this cord is plugging into the RCA Input on the rear of the H12X500UBT. Ensure that the
polarity of your signals always maintained by using color coordinated RCA cables.
NOTE: WHEN MAKING THESE CONNECTIONS THE POWER OF THE H12X500UBT AND THE SIGNAL
SOURCE SHOULD ALL BE IN THE OFF POSITION WITH THE VOLUME LEVELS TURNED DOWN. ONCE
THE UNITS ARE ALL POWERED ON, SLOWLY INCREASE THE VOLUME TO AVOID DAMAGING ANY
OF YOUR EQUIPMENT. THE H12X500UBT OPERATES MOST EFFICIENTLY WHEN USED WITH 8 OHM
SPEAKERS.
Power Cord, MP3 Cable, User Manual, Warranty, Remote Control, Antenna.
Accessories
H12X500UBT
iPod™ & iPhone™ are registered trademarks of Apple Computers, Inc. Apple Computers, Inc. is not endorsing, sponsoring, or otherwise affiliated with this manufacturer.
