P-4
BLUET32LG Operation:
Using the AUX (RCA) Input: Power off the BLUET32LG and lower the volume. Connect the satellite speakers
to the speaker outputs on the rear of the base unit. Connect the AUX source to either the RCA inputs on the
rear of the unit or the 1/8” input on the front panel. Power the unit on. Press the input button until the input
indicator (19) illuminates SOLID green. Begin to play your audio and slowly raise the volume to the desired
levels.
Using the USB Flash Drive / SD Card Input: Power off the BLUET32LG and lower the volume. Connect the
satellite speakers to the speaker outputs on the rear of the base unit. Connect the USB flash drive or SD
Card to the inputs on the front panel of the base unit. Power the unit on. Press the input button until the
input indicator (19) illuminates FLASHING green. Using the controls on the front panel play the audio from
the USB flash drive / SD Card and slowly raise the volume to the desired levels.
Using the Bluetooth Input: Power off the BLUET32LG and lower the volume. Connect the satellite speakers
to the speaker outputs on the rear of the base unit. Power the unit on. Press the input button until the input
indicator (19) illuminates blue. Open the Bluetooth device’s Bluetooth connections and search for Bluetooth
enabled devices. The Bluetooth device should be able to locate a device named “BLUET32LG”. Select this
device and connect to it. The unit will then beep indicating that the unit has successfully paired with the
Bluetooth device. Play music directly on the BLUET32LG directly from the Bluetooth device. Slowly raise the
volume to the desired levels.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Federal Communications Commission Requirements:
The equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
THE CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE
COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
FCC Radiation Exposure Statement
The equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency
(RF) Exposure Guidelines in Supplement C to OET65. The equipment has very low levels of RF energy that it is deemed to comply
without testing of specific absorption ratio (SAR).
The Bluetooth word mark and logos are registered trademarks owned by SIG, Inc. and any use of such marks by Technical Pro is under
license. Other trademarks and trade name are those of their respective owners.
BLUET32LG
