2
SIGNALING LAMPS
1. Receiver :
receives signals transmitted from the remote control.
2. TIMER lamp:
This lamp lights up when the system is being
controlled by the timer or sleep mode.
3. OPERATION lamp:
This lamp lights up during operation.
It blinks once to announce that the remote control signal
has been received and stored. It blinks continuously during
the protection modes (defrosting, etc.).
4. STANDBY lamp:
This lamp lights up when the air conditioner
is connected to the power and ready to receive the remote
control command.
5. Water-level alarm:
When the main tank is full, the air condition-
er stops automatically and this lamp begins blinking.
6. Operation button (without remote control):
Push the button
to walk through the OFF and COOL operation modes.
The OFF position does not disconnect the power. Use the
main power switch to turn off power completely.
WARNING
BEFORE USING THE APPLIANCE
l
Check that the power supply at the location where the air conditioner is going to be used is 220-240V ~ 50Hz .
l
Make sure that the electrical installation is suitable to supply continuously current necessary for the air conditioner in addition to
that already used by other electric appliances (white goods, lighting). See the max electric input indicated on the name plate posi-
tioned on the air conditioner.
l
The installation of a double-pole switch, protected by 10 A fuses of the delayed type, upstream the electricity wall socket, is rec-
ommended.
l
The unit has to be connected according to the local electrical rules.
l
Make sure that circuit breakers, fuses, etc, are of sufficient capacity to handle a
start-up current of 20 A (generally less then 1 second).
l
Do not install the air conditioner where it could be wetted by drops of water (i.e. in
laundries).
l
Before connecting the air conditioner to a power socket, make sure that the sock-
et is provided with an earth connection in compliance with local codes.
l
Never use the power plug as a mean to start or stop the air conditioner: always
use the ON/OFF push-button switch on the air conditioner control panel.
l
Do not move the air conditioner during operation, turn it off and disconnect the
plug from the power supply. Verify and eventually discharge the condensate
water, through the discharge tube located on the rear of the unit.
l
WARNING! Do not stick anything into the air outlet of the air conditioner. This is
very dangerous because the fan is rotating at high speed.
l
WARNING!
The air conditioner is provided with a time-guard system, which does not allow
re-starting of compressor until after 3 minutes from a previous stop.
l
Make sure that there are no obstacles around the unit affecting the free circulation
of air. Do not block the air intakes and outlet of the unit with curtains or other.
Never put objects on the top of the unit.
l
The air conditioner reaches the maximum efficiency at the following conditions:
1-The flexible tube is retracted, without bends and without the outlet nozzle.
l
The manufacturer assumes no responsibilities if the safety regulations or local
codes are not observed.
Always unplug the unit from the power socket before moving or cleaning it.
WARNING
1
2
3
4
5
6
CAUTION
EG
NOTE
The blinking of OPERATION, TIMER and STANDBY lamps,
indicates that the operating mode selected ( ) is not
compatible with the unit. If this happen the air conditioner
does not operate until the correct mode is selected.
USO_374252032_MTF97.qxd 17-01-2007 11:50 Pagina 3
