●
Use DRY operation when you want to reduce the humidity
in the room.
●
Once the room temperature reaches the set level, the unit
repeats the cycle of turning on and off automatically.
●
During DRY operation, the fan speed is automatically set
(Remote control lamp is ON) to prevent overcooling.
●
Dry operation is not possible if the indoor temperature is
10 °C or less.
7
EG
ADJUSTING THE FAN SPEED
AUTOMATIC
Simply set the FAN selector to the position.A
microcomputer automatically controls the fan speed when
the AUTO mode is selected. When the air conditioner starts
operating, the difference between the room temperature
and the set temperature is detected by the microcomputer
which then automatically switches the fan speed to the
most suitable level.
NIGHT MODE / ENERGY SAVING
●
This mode enables you to save energy.
1. Set the MODE selector to cool, dry or heat.
2. Press the NIGHT button.
3. The mark appears on the display. Press the NIGHT
button again to release the NIGHT function.
What does the NIGHT mode mean?
When you select the NIGHT mode, the air conditioner will
modify automatically the set temperature after 60 minutes.
This enables you to save energy without sacrificing your
comfort.
NOTE
FAN ONLY
If you want to make air circulate without any temperature
control, follow these steps:
1. Press the ON/OFF operation button and switch the air
conditioner ON.
2. Press MODE button until only the fan sign
appears on the display.
The above mentioned data make reference to the
conditioner operating when the sensor on the remote control
unit is ON. (Refer to temperature sensor selector). If the
sensor on the indoor unit is being used then actual operation
will slightly differ from that described in the above tables.
The automatic speed is not available in FAN ONLY mode.
NOTE
WHEN DIFFERENCE BETWEEN
ROOM TEMPERATURE AND SET
FAN SPEED
TEMPERATURE IS
Cooling and
2 °C and over
High
dehumidifying
Between 2 and 1 °C
Medium
modes:
Below 1 °C
Low
2 °C and over
High
Heating mode:
Below 2 °C
Medium
High speed
Med. speed
Low speed
MANUAL
If you want to manually adjust speed just set the FAN selector
as desired.
OPERATING MODE
SET TEMPERATURE CHANGE
Heating
Lowered by 1 °C
Cooling and Dehumidifying
Raised by 2 °C
During the NIGHT mode the internal fan speed is
automatically lower and reduces the noise.
NOTA
S
elezio
n
e f
un
zio
n
e
Temperat
u
ra ambie
n
te
1 h
TEMPO
1°C
COOLING AND DEHUMIDIFYING
HEATING
S
elezio
n
e f
un
zio
n
e
Temperat
u
ra ambie
n
te
1 h
TEMPO
2°C
HIGH POWER MODE
When this mode is active the internal fan speed is set
automatically and the air conditioner operates, for 15
minutes, at the maximum power. After 15 minutes from the
selection the symbol on the display switch off and the
mode is automatically switched off.
NOTE
During the high power operation the room temperature
could not correspond to the set temperature.
Function selection
Room temperature
TIME
Function selection
Room temperature
TIME
