97
Installing the Remote Controller
●
If the remote controller is to be installed onto a wall or other surface for use, first place the remote controller in
the location where it will be installed and press
(ON / OFF). Confirm that the “signal-received” sound occurs
at the indoor unit and that the A/C begins operating.
Place in holder
Installation screws
Truss tapping
4 x 16
Press
1
2
●
Installing the batteries
(1) Press on both sides of the remote controller cover
and slide it downwards to remove it.
(2) Insert 2 AAA alkaline batteries. (Pay attention to
the + and – directions.)
(3) Use an object with a sharp point to press the ACL
(ALL CLEAR) button, then reattach the cover.
(Be sure to press the ACL (ALL CLEAR) button
after replacing the batteries.)
Fig. 10-29
Fig. 10-30
To remove the remote controller, pull it towards you.
Precautions for remote controller installation
●
Before mounting the remote controller on the wall, place the unit at the mounting position, then turn on any fluo-
rescent lamps, press the ON/OFF button, and check that the air conditioner operates correctly.
When using the remote controller to detect the room temperature, observe the following precautions during instal-
lation:
• Avoid locations where the remote controller will be exposed to the direct path of air blown from the air conditioner.
• Avoid locations where the remote controller will be exposed to direct sunlight.
• Avoid locations where the remote controller will be exposed to direct heat sources.
04-393 DC INV Tech p 64-110 12/13/04 11:35 AM Page 97
