8
Setup
Gobo Holder
The Gobo Holder uses Standard “E” size Gobos (1.5” / 37.5mm), Metal or Glass. The
fixture produces no significant heat or UV allowing self-printed custom designs on
transparent printer film. Two gobo holders are supplied with the projector.
Remove Gobo Holder
The gobo holder is held in place by magnets. Remove by grasping the scalloped edge of
the holder and carefully lift out.
Install Gobo Holder
Holding by the scalloped edges of the holder, gently set in place.
Changing Gobo
The gobo is held between two pieces that screw together. Unscrew the two pieces to
open the holder. Take care to not cross thread or over tighten.
When installed correctly, the gobo will be backwards when viewed
from the scalloped side of the Gobo Holder or front of the fixture
when installed.
Focus
Focus has separate adjustments for Coarse and Fine. Move the Focus assembly out for
nearer surfaces, and in for surfaces farther away. Best results are obtained by projecting
on a solid white or neutral colored surface.
Coarse
Coarse focus is set by pushing or pulling the
front lens assembly to achieve the best possible
initial focus. Indentations in the support rails
make clicking noises while adjusting. Careful not
to force the lens assembly against the maximum
travel stop.
Fine
Turning the front lens bezel in or out adjusts the
Fine Focus. Careful not to force the movement
at either end of its adjustment limit. If needed,
re-adjust the Coarse Focus and then return to
Fine.
