technetix AIMA3000.ASMM, Руководство пользователя

Страница: 14 / 43

11
Aug/2017 - V1 Technetix Group Limited
Product User Manual
AIMA3000.ASMM
Module fastening screw
Direction of module
installation/removal
2. Hold the AIMA module casing upright, align it with the AIMA3000 slide rails for the correct slot, and insert the
module until it reaches the multi-pin connector.
DO NOT use excessive force when inserting the module, but ensure the RF connectors at the rear of the module
are securely connected with the chassis's RF connectors.
CAUTION!
The module MUST be installed correctly to ensure a proper connection of the module’s multi-pin
connector and the backplane.
Tip:
When inserting the module into the guide rails, vertically tilt the module slightly to check that the guides are properly
seated on the rails. The module is guided to the correct position using the large metal fastening screw on the lower
part of the front panel.
3. After the module is inserted, gently push the hinged tab until it snaps into the orange retaining clip. While pushing
down on the hinged tab, the AIMA module will mate with the power bus and will lock in into the chassis
CAUTION!
If force is required to insert a module, then it may not be correctly seated on the slide rails, or the
mounting screw may be misaligned.
4. When the module is fully seated within the chassis, on the bottom of the AIMA module, fasten the spring-
loaded mounting screw. Only use fingers to fasten the mounting screw. DO NOT use a screwdriver.