21
Aug/2017 - V1
Technetix Group Limited
Product User Manual
AIMA-OPSW
6 Module Configuration & Alarms
The module configuration settings can be configured using the web interface and Technetix NMSE (network management
software). This manual only provides details on the web interface. For login details and network setup, please refer to the
AIMA-ASMM user manual. If the same module is reinserted in the same slot, the ASMM will restore the previous settings if
the module is set to “Auto Download” in the configuration.
6.1 Login to the System Management Web Page
All module configurations, alarms, and monitors are managed by the ASMM module.
Establish network connectivity through the
RJ-45 Ethernet Port 0
on the top of the rear panel of the ASMM. An administrator
can also connect through a local network on a switch/hub if both the module and user are on the same subnet.
6.1.1 Configuration using a PC
Manually configure your network interface card to have an IP address of 192.168.25.x with the subnet mask of
255.255.255.0
.
Connect an Ethernet cable between the ASMM's front
LOCAL RJ-45 Ethernet port
and the PC.
Use a web browser to open the AIMA3000 web configuration interface at the default IP address of
192.168.25.168.
Enter the default Username
(admin)
and Password
(Technetix)
to log in to the AIMA3000 system configuration web interface.
Default user name:
admin
Default password:
Technetix
If you manually change the ASMM's IP address and forget it, you can still connect to the "Backup IP" address at 10.10.10.10.
The IP of the client PC must be set to 10.10.10.9. Typically the front RJ-45 Ethernet port should be used to access the web
interface, the "Backup IP" is only supported after HW_A04259_4 and FW_S08471 01.01.16.
Содержание AIMA-OPSW
Страница 47: ......
