Techly IDATA HDMI-MX373, Руководство пользователя

Страница: 11 / 16

HDMI EXTENDER MATRIX
11
EN
5. Igmp groUp cHosen and nIxIe tUbe dIsplay InstrUctIon
5.1 Button usage instruction
Short press: Press to set IGMP group and display the setted value.Product switches automatically
to the corresponding IGMP group 5 seconds after the press.
Long press: Press and keep 3 seconds to reset the product, only for software. It will not restore
system specification to factory setting.
5.2 Nitie tube display instruction.
When RX and TX display the same value, it builds corresponding IGMP group. RX will output the
same A/V signal with the matched TX. One TX can support 16 ways source signals at the most.
6. Ip and mac address settIng
System module has equipped HTTP server. It can change system IP and MAC address via webpage.
Before building network matrix, the IP and MAC address ofTX and RX must be reset. The principle
is that, all the RX and TX in the same network matrix must be in the same network segment, the IP
and MAC addresses for these RX and TX must be different. TX and RX have a default IP address.
TX is 192.168.168.55, RX is 192.168.168.56. After the change, press the system reset button for 5
seconds(the small hole beside of HDMI port) to restore IP and MAC to default factory setting.
WARNING: Changes the IP address and MAC address are intended to specialized technical
staff, if you are not familiar with this procedure, please check more information before
proceed. Any changes could bring instability in the home or office network. If you need to
change any data, please write down the changes for each product, the products changed
may become inaccessible if you do not take note of the changes made.