TechLine LA35, Руководство пользователя

Страница: 16 / 40

Page 16 of 40
Actuator with relative positioning - Single Hall
I/O specifications:
Input/Output Specification Comments
Description The actuator is equipped with Single Hall
that gives a relative positioning feedback
signal when the actuator moves.
See connection diagram,
fig. 3, page 15
Brown
12-24VDC (+/-)
12V ± 20%
24V ± 10%
Under normal conditions:
12V, max. 10A depending on load
24V, max. 5A depending on load To extend actuator:
Connect Brown to positive
To retract actuator:
Connect Brown to negative
Blue To extend actuator:
Connect Blue to negative
To retract actuator:
Connect Blue to positive
White Signal power supply (+)
10-28VDC
Current consumption:
Max. 40mA, also when the actuator
is not running
Black Signal power supply GND (-)
Green Not to be connected
Yellow Not to be connected
Violet Single Hall output (PNP)
Movement per single Hall pulse:
3mm pitch = 0.38mm per pulse
5mm pitch = 0.63mm per pulse
9mm pitch = 1.13mm per pulse
12mm pitch = 1.5mm per pulse
Frequency:
Frequency is 30-125 Hz on Single Hall
output depending on load.
Every pulse is “ON” for minimum 3ms.
Overvoltage on the motor can result in
shorter pulses.
Output voltage min. V
IN
- 2V
Max. current output: 12mA
Max. 680nF
N.B. For more precise measurements,
please contact
LINAK A/S.
Low frequency with a high load.
Higher frequency with no load.
Diagram of Single Hall:
Red Not to be connected
Fig. 3.1
Micro -
Processor
Input Single Hall output
Hall B
Hall A