Tech Source RAPTOR 1000 - OPENWINDOWS FOR SOLARIS INSTALLATION-REFERENCE, Инструкция по установке и справочник

Страница: 50 / 68

Raptor OpenWindows for Solaris Installation and Reference Manual
A-6
The sync values can be added together to select more than one
of the above.
NOTE: To obtain the timing parameters required to use the
video-timing method, please contact Tech Source with your
monitor's requirements.
A.5 Troubleshooting
Problem:
The Video-Mode method described in Appendix A was used to
change the console resolution but the card does not come up in
the desired resolution.
Possible Cause:
The
output-device
environment variable may have been set
at the
ok
prompt, or the
video-timing
variable may be set in
NVRAM. The resolution specified by the
output-device
variable and the
video-timing
variable takes precedence over
the resolution specified by the video-mode variable. If a
resolution has not been specified by any of these variables, then
the card's default resolution is used. The order of precedence
from highest to lowest is as follows:
1.
output-device
resolution (Section A.2)
2.
video-timing
resolution (Section A.4)
3.
video-mode
resolution (Section A.3)
4. card's default resolution (Section A.1)
Solution:
Clear the resolution specification from the
output-device
environment variable by typing the following:
ok
setenv output-device screen
ok reset-all