25.Use a knife to cut a hole onto the rudder .
26.Glue the control horn by using CA .
27.Fix the servo extension arm onto the servo arm with
screw .
28.Install the pushrod connector onto the extension arm .
29.Install the Z wire onto the pushrod connector , and
then tighten the screw with screwdriver.
30.Center the rudder and elevator , and then tighten the
servo arm .
31.Glue 2pcs of 1.3mm*190mm carbon rods onto the back of
the horizontal stabilizer and the both sides of the under of
thefuselage. To avoid the twisting of the horizontal stabilizer.
32.Use a knife to cut a slot under the fuselage.
33.Glue the tail wheel set into the fuselage slot.
－
5
－
