7
SansAmp RPM Specifications
Note:
With on-going product development and improvements, specifications and/or
the cosmetic appearance of this unit may change without prior notice.
Replacement
parts
are available, i.e., knobs, rack handles, faceplate, etc. For more information,
please contact your authorized dealer or Tech 21.
Model Number:
RPM
Input Impedance-Input 1:
4.7MOhm
Input Impedance-Input 2:
1MOhm
Output Impedance-1/4”:
1KOhm min
Output Impedance-XLR:
600 Ohms min
Input Level-Input 1:
1V RMS max
Input Level-Input 2:
1V RMS or 10V max, with -20dB pad engaged
Output Level-XLR:
Switchable to -20dB or 0dB range
Maximum Output Level:
+10dB or better
Effects Loop Send:
1K Ohm min, -20dB
Effects Loop Return:
100K Ohm min, -20dB
Low Frequency Response:
10Hz or better*
High Frequency Response:
Harmonic content, 20kHz or better*
Maximum Power Consumption:
5 Watts
AC Input Power (factory set):
100V, 117V, 230V, 240V
Cycles:
50/60 Hz
NOTE: Each unit constructed for specific voltages. AC power cannot be switched.
Enclosure:
Aluminum and steel, fully shielded
Dimensions:
19.0"w x 1.75"h x 5.25"d / Overall depth: 6.25"
Weight:
5 lbs.
*Due to the variety of amplifier emulations available, frequency response
characteristics will vary.
8
To FOOTSWITCH IN
of SansAmp RPM #2
or SansAmp RBI
To FOOTSWITCH
LINE or INST
LEVEL IN
*
LINE or INST
LEVEL IN
*
To AMP
To SansAmp RPM #2/SansAmp RBI
SansAmp RPM #1
SansAmp RPM #2/SansAmp RBI
CHAINING 2 SansAmp RPMs or to an RBI
GENERAL
"BIAMP" with SansAmp RBI and SansAmp RPM
LINE or INST
LEVEL IN
LINE or INST
LEVEL IN
*
To AMP #2
To AMP #1
To SansAmp RPM
SansAmp RBI (set to distorted Highs)
SansAmp RPM (set to clean Lows)
To MIXER
To MIXER
CHANNEL A
To MIXER
CHANNEL B
HOOK-UP DIAGRAMS
*NOTE: Engage 0dB pad when biamping.
*NOTE: Set both units at same level,
according to the instrument's output.
"Biamp" with channel switching can be accomplished with four units.
For hook-up details, contact Tech 21.
DRY SIGNAL
to MIXER or
RECORDER
To OUTPUT
of PROCESSOR
To FOOTSWITCH
DRY FEED to 2nd
AMP, PREAMP or PROC./
TUNER OUTPUT
LINE or INST
LEVEL IN
To MIXER
of PA or
RECORDER
To AMP,
POWER AMP, MIXER,
RECORDER or
SOUNDCARD
To INPUT of
PROCESSOR
To
FOOTSWITCH
IN of 2ND RPM
or an RBI
