Teccpo TDLM4065A, Руководство пользователя

Страница: 13 / 25

When the battery state of charging as show:
1.
2.
3.
4.
5.
Notice:
1.
2.
3.
4.
Inserting the battery
(2-7)
1.
2.
3.
4.
5.
OPERATION
Adjusting the cutting height (8)
1.
2.
Note: For non-grass collection the mower can be used without the grass box in position,
with the safety guard in the down position.
Emptying the grass catcher (11)
1.
2.
3.
4.
Switching on the motor (12)
The motor of this lawnmower does not accelerate to its full speed immediately when the motor
is started.
Only when you move the lawn mower onto the grass to be mown does it detect the grass and
accelerate the motor to the maximum blade speed, then it remains at the maximum blade
speed.
This audible increase in the motor's noise level is completely normal and means that the lawn
mower is cutting at the optimum blade speed.
Start the lawn mower only on level ground, and not in high grass. The ground must be free from
charged less then 30%(the 3 green lights flicker from right to left)
Have filled 30%(Middle green light flicker,the right green light always on)
Have filled 60%(the left green light flicker,the right 2 green lights always on)
Have filled 100%(press the button , The 3 green light shows)
High temperature protection inside batteries(Battery cooling,Pause charging)
Before charging, please check that the lead wire of the charger is not damaged.
Do not charge in a premature wet environment.
Do not charge immediately after the battery is used. The battery pack will be cooled for a
period of time before charging.
Ambient temperature affects battery charging,Please store it in low temperature environ-
ment. Charging temperature range about 0-45
℃
.
Pull the battery cover on the mower to open it. (2)
Turn the safety key to 0. (3)
With a slight pressure push the battery into the battery compartment up to the stop until the battery
sits firmly on the contact plug of the mower. (4)
Insert the safety key again and turn it to 1 or 2. (5,6)
Press once on the battery cover to close it. (7)
To unlock, press the lever to the side and hold.
Release the lever and slide it forward or backward until it engages in the desired step.
Lift the baffle plate.
Unhook the grass catcher and remove it to the rear.
Empty grass catcher.
Lift up the baffle plate and hang the grass catcher back into the holders. (9)
CAUTION!
Danger risk of injury!
Adjust the cutting height only while motor is switched off and the cutting blade has
stopped!
- 13 -