tecan Balance Kit for SAG 285/01, Руководство по эксплуатации, Страница: 24 / 40

4 - 6 Balance Kit Operating Manual, 393278, en, V1.0
4 - Putting into Operation
Setting up the Balance Kit and the SAG 285/01
Connection
via Uniport
As has been mentioned earlier (see section 3.3.1, 3-6 ) the SAG 285/01 may be
connected via the Uniport board under the following conditions:
Š Uniport board must be installed and connected to the Optibo board as shown
in the following figure.
Š The connection via the Uniport is only supported by Instrument Software
versions V4.5 or earlier.
Note: This configuration requires a gender changer between the LC-RS9 cable
(K) and the Uniport board. A special intermediate cable (N) that serves as a
gender changer is available from Tecan (see section
7.1.2, 7-2 ).
Procedure To connect the SAG 285/01 and the instrument to the computer:
1 Decide which of the following connection methods is suitable in your case:
–
Direct connection to two RS-232 ports (see Fig. 4-2 , 4-3 ).
– Mixed connection, instrument to RS-232 and SAG 285/01 via a USB to
Serial converter (see Fig. 4-3 , 4-4 ).
– Connection via USB to Serial converter (see Fig. 4-4 , 4-5 )
– Connection of SAG 285/01 via Uniport (see Fig. 4-5 , 4-6 ).
2 Connect the units together.
3 If you use a USB to Serial converter you must also install the appropriate
driver software on the computer. Follow the instructions provided by the
supplier of the converter.
4 Check your installation.
Fig. 4-5 Connection via the Uniport
Computer
Instrument
RS-232
Optibo-Board
RS-232
Uniport
RS-232
H
L
J
I
M
K
N
H Weighing Cell
I Cable Weighing Cell to Control Unit
J Control Unit
K LC-RS9 (Control Unit to Uniport)
L Power supply for SAG 285/01
M Cable instrument to computer
N Intermediate cable between LC-RS9
and Uniport (gender changer)