TEC 710, Руководство по установке

Страница: 3 / 16

3
TEC-61157-1 Installation Manual-700/710 USB
Table 1. Trigger indication
LED flashes Note
x1
Public order feature
x2
Hood was opened
x3
Trunk was opened
x4
Door(s) was opened
x5
Shock sensor (triggered)
x6
Shock sensor (warning)
x7
Tilt/movement sensor was triggered
x8
Optional sensor (triggered)
x9
Optional sensor (warning)
Arming the alarm in sensors off mode
If you would like to turn audible alert off.
1. Arm the alarm.
2. In 3 seconds press button of the remote, siren will make one
long audible signal, then pause and one short signal— warning
mode will switch off. Alarm will not react to warning trigger
from sensors.
3. In next 3 seconds press button again — siren will make song
signal, then pause and 2 more signals — all sensors will switch
off
Trunk opening without leaving the security mode
You can open the trunk with remote or keyless system. While trunk
is open alarm will stop reacting to sensor input, but will control doors
so the vehicle will stay secured from intrusion. After trunk is close the
system will secure it and turn all sensors back on.
Disarming with PIN code
Alarm can be set up so it requires PIN code to be entered to be
disarmed. If PIN code wasn’t entered in 30 seconds after opening any
door, trunk, or hood.
PIN code is required only if alarm was armed for more than 30
seconds. To turn the alert off enter PIN code.
PIN
TO
Drive®
PIN
TO
Drive® — is a feature designed to prevent vehicle from being
stolen from parking space.
PIN
TO
Drive®
goes into effect if ignition was
switched off for more than 3 seconds. If
PIN
TO
Drive®
feature is enabled
and active it requires PIN code to be deactivated, otherwise engine will
be locked.
• Engine will be switched off on attempt to move if speed control
is enabled and supported by the vehicle
• The engine will be turned off within 5 seconds after the ignition
has been turned on, if the Speed control is disabled or is not
supported by the vehicle.
AntiHiJack
AntiHiJack — is a function that prevents the vehicle from being
hijacked or stolen from its parking area.
AntiHiJack enters the Guard mode in the following cases:
• Ignition was turned off for more than 3 seconds (if
PIN
TO
Drive®
is disabled; otherwise it will work by its algorithms)
• Drivers door was opened.
Upon entering the Guard mode, AntiHiJack feature goes through
a sequence of phases and in case if the Guard mode has not been
deactivated,the feature will activate the engine lock. Changing of
phases takes place only when the ignition is on. When ignition has been
turned off the Alarm will save its current condition and will continue its
operation when the ignition is back on. AntiHiJacks Guard mode can
be deactivated at any phase by entering the PIN code. Guard mode
includes the following phases:
• Idle phase
• Warning phase
•
Locking phase
Idle phase. In this phase AntiHiJack follows two different algorithms
depending on the availability of Speed control.
If the Speed control is available, AntiHiJack waits until the vehicle
covers a set distance from the moment of Guard mode activation.
Upon that, AntiHiJack goes into the Warning phase. If the Speed
control is not available, Idle phase consists of three stages:
• Waiting for drivers door to close
• Waiting for preset amount of brake presses to be made
• Pause before going to warning phase
Warning phase contains 2 stages:
• Warning the driver with the trill that they have to enter PIN-
code.
• Warning other drivers on the road of the possible hazardous
situation due to the upcoming engine locking (10 seconds). It
is carried out by vehicle hazard lights. Driver warning is still on.
Locking phase. Engine lock is activated.