4
In setup mode, XPS will store all settings such as neutral, forward or endpoint position inside the
XPS memory and will not lose even if it is disconnected from the battery.
Notes:
1.
If you find the Throttle or Brake is reversed, please reverse it back to normal position in
the transmitter and go to step 2 to setup the speed control again.
2.
If you find the ORANGE LED keep blinking at neutral position, it indicates it is at zero
timing mode without any timing function to the motor.
Step 2: cont…
◎
Move the throttle stick to the full throttle position, then the flashing ORANGE light will
changed to GREEN light which indicates the full throttle position has been set.
◎
Move the throttle stick to the neutral position again, then the flashing GREEN light will be
changed to the fixed ORANGE light again that means
throttle range setting
has been
completed.
Step 3: Double check the speed control function:
The speed control can be checked based on the below LED status.
Functions
Status LED Color
Neutral Orange
Full Throttle
Green
Full Brake
Red
◎
If the above LED status is correct corresponding to the speed control function, then the
setup procedure has been completed and the XPS is ready to use.
◎
If you make a mistake during the setup procedure. Please turn off the unit first and repeat
the Step 2 procedure.
