Fast charging and storage preparation of a lithium battery
Fast charging a lithium battery
Number
of
cells
L i P o F A S T CHG
2.0A 11.1V(3S)
L i 3 S 2.0A 12.59V
FAS 022:43 00682
-
Batt type
Stop
Elapsed
time
+
Charge
current
Supplied
capacity
Start
Enter
-
‘>3 seconds’
+
Current
voltage
battery
Storage preparation of a lithium battery
19
As the charger reaches the end of the charging cycle, the charging
current will drop. A specific CV process will be reduced to end the
charging process earlier. In fact, the charging current will drop to
1/5 when the charging process comes to 1/10. Charging capacity
will be less than normal charging, but charging time will be
shortened accordingly.
You can set up the charging current and voltage of the battery
pack. Press the ‘START/ENTER’ key to display voltage confirmation.
Then press the ‘START/ENTER’ key again to confirm and begin
charging.
This function is for charging/discharging lithium batteries which will not be used immediately. This
program is designed for charging or discharging batteries to a state suitable for extended storage.
The following voltages are recommended for extended storage: 3.75V Lilo, 3.85V LiPo, and 3.3V
LiFe. The program will begin to discharge if the original state of the battery exceeds the storage
voltage level or charge if below this voltage level.
This screen shows the real-time status of fast charging. Press the
‘BATT TYPE/STOP’ key once to stop charging.
