Page 5
Crash Damage
If there are signs of smoke or overheating, DO NOT go near the battery or equipment until it has been observed
from a safe distance for at least 15 minutes. Once it is safe, remove the battery and check for damage. Dispose of
damaged batteries appropriately.
Swollen Batteries
Immediately
stop using or charging. If the battery is not warm to the touch, move it to an open safe area and observe
it for at least 15 minutes. Be VERY CAREFUL when moving the batteries. Do NOT put ANY pressure on the batteries
or covering as this may cause fire.
Additional Information & Guidelines
1. Battery temperature the best indicator for safety. The Losi Li-Po Battery’s temperature should never drop below 32
degrees Fahrenheit or go above 130 degrees Fahrenheit while charging or discharging.
2. Changing plugs is NOT recommended as the process is dangerous and any error can cause immediate fire.
Improperly installed plugs can also cause fire due to shorts, reverse polarity or other improper handling which can
cause battery damage.
3. Batteries should be stored in a vented, fire resistant container. Each pack should be stored in its own locked
plastic bag within the container. The number of battery packs per container should be extremely limited to avoid
chain reactions. Storage temperatures should not fall below 32 degrees F or above 130 degrees F. Damaged
batteries must be kept at even more ambient temperatures. High temperatures may cause fire even with
undamaged batteries.
Battery Disposal
Li-Po batteries require special handling for safe disposal. The following are basic instructions for safe
disposal. For more detailed safety, disposal and recycling information please go to: www.rbrc.org or www.
earth911.org.
Basic Disposal Instructions
Before discarding any Li-Po battery it must be rendered safe. The following steps must be taken to avoid damage or
injury to yourself, your property and anyone who comes in contact with the battery.
If the battery is undamaged but no longer useful:
1. Discharge the battery to a maximum of 2.5V using a slow, safe discharge method.
2. Leave battery uncharged and retest after at least 24 hours. Many batteries experience “rebound” and may have
more than 2.5V after 24 hours. If the battery is over 2.5V, repeat the procedure until the battery is 2.5V or less.
3. Insulate each wire lead with electrical tape or other appropriate material.
4. Assure that wire leads cannot touch each other by taping them to opposite sides of the battery.
5. Place battery in a sealed plastic bag and place plastic bag in a vented, fire-safe container.
6. Use fire-safe container to deliver battery to a recycling center authorized for Lithium Polymer batteries. Please
note that not all battery-recycling services include Li-Po’s. If no Li-Po recycling facility is available in your area,
contact your state or local Hazmat agencies for instructions.
7. If the battery or wiring is damaged please contact your state or local Hazmat facilities for instructions. Batteries
must be rendered safe before being transported or recycled. Do NOT transport or ship batteries which have more
than 2.5V charge OR that show signs of damage without following the instructions given by authorities. Damaged
batteries should be rendered as safe as possible and stored in a vented fireproof container until recycled.
