Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The page must be reproduced and folded in order to obtain a mini
booklet A5 (+/- 148.5 mm width x 210 mm height). The page must be
folded in order to keep the good numbering when you turn the page
of the I/B. Don’t change the page numbering. Keep the language
integrity.
12
TKG GRB 1002 - 151124
Assembly page 12/33
Fax +32 2 359 95 50
symbol means: CAUTION, this surface may get very hot during
use.
The symbol
is always put on the surface with the highest
temperature, however the other metallic or non-metallic surfaces
can also become very hot during use and it is therefore advisable
to always handle them with care and if possible with the help of
isothermal gloves or other thermal protection. In case of doubt
concerning the temperature of a certain surface it is always
preferable to protect oneself.
(*) Competent qualified electrician: after-sales department of the
producer or importer or any person who is qualified, approved and
competent to perform this kind of repairs in order to avoid all danger.
In case of need, you should return the appliance to this electrician.
MOUNTING (SEE PAGE 2, PICTURE
)
1.
Remove all packaging material.
2.
Your appliance is delivered with 4 feet that have to be
mounted before each use (once in place they cannot be
removed). Therefore, turn round the appliance and screw
the feet in the places foreseen to that end.
3.
Assemble the feet of the stand by putting the large lower part and the small upper part of
the feet together. Put small rubber feet on both ends of the feet.
4.
Attach the 4 supporting plates to the 4 feet using the screws and butterfly nuts supplied. Pay
attention to position the butterfly nuts on the side of the small supporting plates.
5.
Put the middle rack on the supporting plates. The stand is now ready.
6.
Put the grill casing on the stand and make sure that the 4 feet are inserted into the openings
at the bottom of the grill casing. Check its stability.
7.
Put the reflector into the grill casing in such a way that the screw situated in the grill casing
(front side) enters into the opening situated on the large side of the reflector, and then
screw the nut onto the screw.
8.
Insert the metal stake into the grill casing. To do so, fit the extremities of the stake into the
two holes in the lateral sides of the reflector
and of the grill casing. To keep the metal
stake from moving, fix it with the 2 plastic plugs included.
Note: this metal stake has to be
mounted in order to support the heating element.
NEVER USE THE APPLIANCE WITHOUT THE REFLECTOR!
BEFORE THE FIRST USE
Clean the grill and the accessories (c
f. “Cleaning and care”). It is recommended to heat up
the barbecue grill for about 10 minutes without any foodstuff in order to eliminate the grease
that may have adhered during man
ufacture and the “new”
smell. When using the appliance
indoors, ventilate the room during this period.
