27
functions
description
settings
17 – AOP
automatic power-on
ON/OFF
In active state (ON), the radio powers on automatically once
power is applied.
This feature is useful if the radio should automatically be in ope-
ration mode once the vehicle is powered on.
18 – MIG
microphone sensitivity
1-16
The communication with stations that transmit very strong signals
can cause feedback. In this scenario it is advantageous to reduce
the microphone sensitivity. The higher the value, the higher the
sensitivity.
19 – RESET
default settings
SETUP/FACT
The selection SETUP resets all settings to the individual software
programming.
The setting FACT resets all settings to the factory preset.
This feature can be deactivated by software. If deactivated the
settings SETUP and FACT are not offered any more.
Please make a data back-up of your individual programming.
External speaker jack
The MiCo is equipped with a 3.5 mm socket (9) at the rear panel to con-
nect an external speaker of 4-8 ohm impedance, e.g. TEAM TS-500.
At 4 ohms, the speaker load can be 4 watts. When the external speaker
is connected, the internal speaker is muted.
functions
description
settings
10 – OFFSET
frequency shift
0-90 MHz
This setting concerns only the commercial versions UHF-/VHF-
COM.
The, for repeater operation, required tx-frequency shift is set in a
range between 0-90 MHz. The frequency steps can be changed
- 5/6.25/10/12.5/20/25/50 kHz.
11 – STEP
frequency resolution
5/6.25/10/12.5/20/25/50 kHz
This setting is only of importance for the commercial radio version.
It defines the frequency resolution for the frequency shift.
12 – dSP
channel display modes
CH / FREQ / NM
The available display modes are channel number (CH), frequency
(FREQ) or channel name (NM) (if programmed).
With the selections FREQ and NM, the channel number is addi-
tionally shown.
13 – bEEP
warning tone
ON/OFF
In active state (ON), every key operation is confirmed with an
acoustic signal, i.e. beep tone.
14 – TOT
time-out-timer
OFF/1-30 min
In active state (1-30 min), the transmission is automatically deac-
tivated upon expiration of the set TOT time. With the PMR and
FreeNet Version, the TOT time is limited to 180 seconds due to re-
gulations.
15 – APO
automatic power-off
OFF; 30/60/120 min
In active state (30/60/120 min), the radio automatically powers off
after expiration of the selected time.
16 – SQL
squelch
OFF/1-9
The squelch level determines the threshold for the required signal
strength to be audible in the speaker. The higher the value, the
stronger the signal has to be in order to pass the filter.
If the squelch is off, the typical, constant frequency noise is audible.
26
man_MiCo_v4en_Layout 1 21.07.2017 15:47 Seite 26
