Team Blacksheep TBS UNIFY PRO32 5G8 nano, Руководство пользователя

Страница: 14 / 19

Button not working
When the Unify Pro32 detects a signal on the RX pad, it will disable the button. To change the VTX to CRSF
or SA, you can unsolder the wire or force your Crossfire/ Tracer RX to not output any signal.
● Set the output of the Tracer RX to CH X (PWM) for the pin the VTX is connected to
● Shut down the Tracer TX and RX
● Power up just the drone with the Tracer RX and the Unify Pro32
● Change the Unify Pro32 settings by the button
● Turn the transmitter back on
● Set the output map back to CRSF or SmartAudio
On the HV version this can be done by the Agent X as it got a USB port
If you have set up everything correctly, you should see the Unify32 in the Lua script, Tango device menu or
the Crossfire oled display (FW 3.21 or later required).
Control by PWM channel (Unify PRO32 Nano only)
This is a simplified method to use a single channel as a button to modify the VTX channel, depending on
the radio controller you may need to reverse the channel output. Connect the PWM output from your
receiver to the Smartaudio/CRSF RX pin. The operations are as follows:
● Short push the button to increase channel.
● Long push the button ( >3s ) to increase band.
● Longer push the button ( >5s ) to reset VTX channel to A1.
14