Teac T-R610DAB, Руководство пользователя

Страница: 16 / 60

16
Troubleshooting
If you have problems with your system, look through this chart
and see if you can solve the problem yourself before calling your
dealer or TEAC service centre.
No power
e Check the connection to the AC power supply. Check and
make sure the AC source is not a switched outlet and that,
if it is, the switch is turned on. Make sure there is power to
the AC outlet by plugging another item such as a lamp or
fan.
e Press the POWER switch to turn the unit on.
No sound
e Check the connection to the amplifier.
e Check the operation of the amplifier.
The sound is noisy.
e Place the antenna as far away from a TV or a CD player as
possible.
e
If a TV or a CD player is near the unit, turn it off.
Cannot listen to any station, or the signal is too weak.
e Make sure the antenna is properly connected.
e Tune in the station properly.
e Install the antenna again after relocating it to a better
reception position.
e An external antenna may be required.
Though the FM broadcast is stereo, it sounds monaural.
e In FM mode, press the ENTER button to switch to AUTO
mode.
‘NO stations Available’ appears on the display.
e Check that antenna is stretched.
e Ensure that DAB coverage exists in your area.
Cannot access secondary services.
e
Secondary service is part-time programme transmitted as a
side channel of the primary station. When you want to listen
to a secondary station, check its broadcasting schedule.
Display goes out or displays ‘service off air’.
e This may occur if a broadcaster changes the label of a
service or removes a label whilst you are listening to it. The
T-R610DAB will try to retune to this station, or alternatively
follow the procedure for Auto Tune on page 7.
Cannot listen to the selected station.
e Ensure you have pressed the ENTER button when you want
to listen to your selection. Or set the Auto Select function on
(see page 8).
A burbling sound is heard on some stations.
e
DAB like other digital media is good at producing quality
audio from a low level signal. However, if this signal level is
too low, a ‘burbling’ sound can sometimes be heard. To
reduce this, try repositioning your antenna to gain maximum
signal strength.
Malfunctions caused by electrostatic discharge necessitate
resetting the product to resume normal operation. To
reset the product, simply unplug the power cord from the
power outlet and plug it back in.
Software version
To display the software version:
1. Press and hold the INFO/RDS button for longer than 2
seconds. ‘System Reset’ is displayed.
2. Press the INFO/RDS button once or twice to display
software version.