15
ENGLISH
14
Setting the Clock
Turn the Skip rotary knob (
.
or
/
) to adjust the clock.
3
Gently close the disc cover by hand.
When closing, press the OPEN/CLOSE
mark (
L
).
5
Press and hold the TIME ADJUST
button for more than 3 seconds and
release it when the time display
starts blinking.
2
<
If you leave the unit idle for 60 seconds,
the time setting mode will be cancelled.
Press the OPEN/CLOSE mark (
L
) to
open the disc cover.
1
4
3
5
1
2
<
If the unit is disconnected from the
power supply for about 30 minutes, the
clock setting will be reset.
Press the TIME ADJUST button.
The clock starts from 00 second.
4
The provided Remote Control Unit allows
the unit to be operated from a distance.
When operating the remote control unit,
point it towards the remote sensor on the
front panel of the unit.
<
Even if the remote control unit is
operated within the effective range,
remote control operation may be
impossible if there are any obstacles
between the unit and the remote control.
<
If the remote control unit is operated near
other products which generate infrared
rays, or if other remote control devices
using infrared rays are used near the unit,
it may operate incorrectly. Conversely, the
other products may also operate
incorrectly.
1
2
3
1. Remove the battery compartment cover.
2. Put in the lithium battery (CR2032, 3V).
3. Close the cover.
Battery Replacement
If the distance required between the
remote control unit and main unit
decreases, the battery is exhausted. In this
case, replace the battery with a new one.
Precautions concerning batteries
Do not heat or disassemble batteries and
never dispose of old batteries by throwing
them in a fire.
Remote Control Unit
Battery Installation
DST (Daylight Saving Time)
Select ON to put the clock one hour
ahead. Select OFF to turn the DST off.