Teac PL-D200V, Руководство по обслуживанию

Страница: 11 / 135

13
TEST MODE
TEST Mode shows the infomation as follows.
I. Back End Version (It is to express each Buyer, each model, and version number.)
II. Front End Version (It is to display the Mecha Fimware version number.)
III. Back End Build time (It can be used to seperate each B/E firmware version by the day.)
IV. Region No.(It is only to display region code.)
[operation]
To enter the first state of test mode, first open DISC. (Press OPEN key.)
then, press key on the remote unit as follows.
[CLEAR] - [2] - [5] - [8] -[0] - [CLEAR]
If you press key correctly, you will see the message below.
BE VER MODEL No. - (I : B/E version)
FE VER 61-500101
- (II : F/E version)
BUILD TIME 20030510B - (III : B/E bulid time)
REGION
xx
- (IV : Region Number)
<B/E Firmware update> : Function 2
The update is done with CD-R. (When the firmware is changed, the updated firmware will be provided by Anam on CD-R)
Put the DISC in at the first state of service mode and then press the PRGM key on the remote unit.
Updating will begin as follows.
ERASE -> WRITE -> DONE
You'll see the update sequence on the TV screen.
ERASE >>>>>>>>>>>>
WRITE >>>>>>>>>>>>
DONE
When the TV screen's display goes off, turn the POWER OFF.
Turn the POWER ON and then DO EEPROM CLEAR.
<F/E Firmware update> : Function 3
The update is done with CD-R. (When the firmware is changed, the updated firmware will be provided by Anam on CD-R)
- Put the disc on OPEN at normal operation mode.
- Press PLAY on the remote.
- After about 30 seconds, DVD door will be open.
- Turn the power off.
- Turn the power on and open DISC
- Remove the disc.
Note: F/E update method has another method. It is that you can update in the normal mode, same
sequence, same method. Updating in the normal mode is recommandable because of updating
during the short time. In this case, you must confirm the F/E firmware version.