Teac EU2890ST, Руководство пользователя

Страница: 14 / 20

14
SOUND OFF
Press the key Ï
’
on the remote control and
turn off the sound - the sign Ï is displayed on the
screen. Press the same key once again and turn
on the sound. To turn the sound on again, you
can also use the
t
”
and u
–
keys on the
remote control or the
§
-
%
and
§
+
&
keys on
the control unit. By holding these keys pressed,
the volume will continuously increase or
decrease, starting at the value set before turning
the sound off.
HEADPHONE SOCKET
You can connect headphones to stereo
headphone socket. To this socket you can
connect stereo headphones with min.
impedance 8 Ohm and 3,5 mm plug. If the plug
of your headphones is different use an adequate
adapter. Set the volume wit keys on remote
control and control unit panel.
When you switch off the headphones,
loudspeakers automatically switch on.
RECALLING THE STORED VALUES
To recall the stored values of picture and sound
press the
N
¤
key. The "PERSONAL" sign
appears on the left of the screen. By pressing the
N
¤
key once again within 5 seconds the "DAY"
(picture pre-set daily) sign appears on the left
side of the screen. By pressing the
N
¤
key once
again within 5 seconds the "NIGHT" (night
adjustment) sign appears on the left side of the
screen (brighter or darker picture).
By pressing the N
¤
key once again the stored
values "PERSONAL" are restored. Any
modifications of the picture or sound, which are
adjusted in the menu, shall be stored in
"PERSONAL" . "DAY" and "NIGHT" are pre-
set in the factory and cannot be modified.
EURO-AV INPUT - SCART
Any of the video devices with a video output
(VCR, videocamera, satellite receiver,
computer...) can be connected to the SCART
socket. If AV signal is connected (terminal pin 8
on SCART connector) the TV set is automatically
switched over to AV mode, when an external
device is connected. If there is no AV signal ,
successively press the
AV
Š
key and move up or
down the following ranges:
•
AV key - first press
Š
: AV1 (SCART 1),
•
AV key - second press
Š
: AV2 (SCART2),
•
AV key - third press
Š
: YUV (Component
input Y, Cb, Cr)
•
AV key - fourth press
Š
: S-VIDEO (Mini DIN,
AUDIO L, AUDIO R),
•
AV key - fifth press
Š
: AV3 (CINCH INPUT
VIDEO, AUDIOL, AUDIO R),
•
AV key - sixth press
Š
: TV mode, (antenna).
Return to TV mode by pressing the key ›
¢
.
If you want to record a certain program on VCR,
activate the
"VIDEO OUT" function in the
"SPECIAL" menu in the position "ON" !