An List Schedule EPG dialog is provided that presents some
extended schedule EPG information, either on a banner for
the current service, or as a full screen dialog showing multiple
services, follow these steps below to enter the dialog:
Move the hightlight bar until List Schedule EPG in Guides
submenu, and press SELECT button to enter the dialog as
figure29.
In this dialog, the leftmost list displays all available services, the
current selected service is displayed in the title bar of the list. The
rightmost list displays two hours of schedule information for the
currently selected service, its title shows the time span covered by
the list. You can navigate between the two lists to change the
selected service or the highlighted programme by pressing
LEFT/RIGHT buttons, and you can also change the time span of the
schedule information displayed for a channel by either two hours or
an entire day through pressing RED/GREEN button or YELLOW/BLUE
button on the remote control.
In the case when there is no schedule information available, the list
shown on the dialog will display the label No Information Available.
Press ESC to quit current menu and go back its previous
menu, or press DTV MENU directly to exit main menu.
Now/Next EPG
Guides
List Schedule EPG
Electronic Programme Guide
ABC TV
14:35 Something in the air
15:20 Play School
15:25 Balamory
15:45 Arthur
15:55 Little Lulu
16:10 Get Your Own Back
16:35 That's Genius!
Something in the air
14:35:15:20
Wed 19/11, 15:00-17:00
1. ABC TV
2. ABC TWO
[Entertainment] Under Wraps: When a phial of deadly nerve poison is
stolen from a laboratory, and Sir Matthew Osterson who runs a nursing
home receives a blackmail letter, Bergerac attempts to solve the...
Wed 19/11, 15:24
More
i
Navigate
Advance Day
Change Time
Figure28
Figure29
6. DTV OPERATION
28
NOTE:
In DTV main menu, press SELECT button to enter Channel List dialog, or directly press List
button on the remote controller to enter Channel List dialog, press UP/DOWN button to
highlight a channel, and press SELECT button to select the channel as current channel, then
press DTV MENU or LIST button to exit the dialog and watch the current selected channel.
In DTV mode, you can select a program by directly pressing P-/+ button or digit button. For
example, if you selected CHANNEL 7, and the following six sub-channels,7.7, 70.7, 71.7, 72.7
, 73.7, 77.7, has existed in the channel. You can watch the program of 71.7 by directly pressing
the digits 7 and 1. Next, if you press P+ button, your TV will access to the program of
.
If you press digit 7 and 4 buttons, your TV will access to the program of 73.7, because 73 is the
closest and smallest digit to 74.If the current sub-channel is 73.7, when you press P+ button,
your TV will access to the program of 77.7, that is to say, any empty program can not be selected
by pressing P+/- button or digit buttons.
In DTV mode, some audio programs without picture can be received.
72.7
Your TV is fit for MPEG-2 standard and AUSTRALIA DVB-T standard. It is a standard
definition handled module, so the TV can not decode high definition (HD)content, it
can only decode standard definition content. When your TV selected a program of high
definition, the following dialog will appear on the screen:
can not decode HD content
.
