Rear Panel Overview
1
Audio signal jacks:
Note:
Make sure that you connect the white pin-
plug to the white jacks (left) and the red
pin-plug to the red jacks (right).
…
PHONO input jacks
Connect the output jacks of the record
player (turntable) to these jacks.
…
AUX input jacks
Connect the output jacks of the VCR or
other AUXiliary source unit to these
jacks.
…
CD input jacks
Connect the output (LINE OUT) jacks of
the CD player (PD-H570) to these jacks.
…
MD/TAPE 2 (PLAY/REC) jacks
These jacks are used for the connection
of the MD player (MD-H500) or the
second cassette deck.
Connect the output (LINE OUT) jacks of
the MD player or cassette deck to the
PLAY jacks; the input (LINE IN) jacks of
the MD player or cassette deck to the
REC jacks.
…
TAPE 1 (PLAY/REC) jacks
Connect the output (LINE OUT) jacks of
the cassette deck (R-H500) to the PLAY
jacks; the input (LINE IN) jacks of the
cassette deck to the REC jacks.
2
Speaker terminals (see page 3.)
3
Antenna terminals
4
RESET switch
Press the RESET switch once or twice with
a pencil or a ball-point pen lightly.
…
If you press this RESET switch, all the
memories will be erased. In this case, try
to preset stations again.
5
REMOTE CONTROL jacks
These jacks are used for the connection of
the TEAC Mini component system (PD-
H570, PD-H500, R-H500) for the purpose of
operating it using the Remote Control unit
(RC-613 provided with the receiver) or
system control signals.
6
AC OUTLETS (unswitched)
Plug the AC power cord of the source unit
(CD player, cassette deck, etc.) into this AC
OUTLETS.
7
AC power cord
Plug the AC power cord into an AC wall
socket.
8
Main power switch
Press the ON side of this rocker (seesaw)
switch to turn the power ON (standby
position); press the OFF side to turn the
power off.
Note:
Leave the main power switch ON at all
times.
– 4 –
7
8
6
4
5
3
2
1
