_ 3 _
ENGLISH
PRECAUTIONS
TO THE USER
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against interference in a residential area. This
device generates and uses radio frequency energy
and if not installed and used in accordance with
the instructions, it may cause interference to
radio or TV reception. If this unit does cause
interference with TV or radio reception you can try
to correct the interference by one or more of the
following measures:
a) Reorient or relocate the receiving antenna.
b) Increase the separation between the
equipment and the receiver.
c) Plug the equipment into a different outlet so
that it is not on the same circuit as the
receiver.
If necessary, consult the dealer or an experienced
radio/TV technician for additional suggestions.
CAUTION
Changes or modifications to this equipment not
expressly approved by TEAC CORPORATION for
compliance could void the user's authority to
For U.S.A.
VOLTAGE CONVERSION
Be sure to remove the power cord from the AC
outlet before repositioning the voltage converter
switches.
1. Locate the voltage selector on the rear panel.
2. Using a flat-bladed screwdriver, set to the
appropriate 120 V or 230 V position according
to your area.
For General Export Models
The equipment draws nominal non-operating
power from the AC outlet with its POWER switch
in the STANDBY position.
Obs! nätströmställare ¨n skiljer ej hela apparaten
från nätet.
NOTE FOR U.K. CUSTOMERS
DO NOT cut off the mains plug form this equipment.
If the plug fitted is not suitable for the power points in
your home or the cable is too short to reach a power
point, then obtain an appropriate safety approved
extension lead or consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse
and dispose of the plug immediately, to avoid a possible
shock hazard by inadvertent connection to the mains
supply.
If this product is not provided with a mains plug, or one
has to be fitted, then follow the instructions given below:
IMPORTANT. DO NOT make any connection to the
larger terminal which is marked with the letter E or by the
safety earth symbol
©
or coloured GREEN or GREEN-
and-YELLOW.
The wires in the mains lead on this product are coloured
in accordance with the following code:
BLUE:
NEUTRAL
BROWN:
LIVE
As these colours may not correspond with the coloured
markings identifying the terminals in your plug proceed
as follows:
The wire which is coloured BLUE must be connected to
the terminal which is marked with the letter N or coloured
BLACK.
The wire which is coloured BROWN must be connected
to the terminal which is marked with the letter L or
coloured RED.
When replacing the fuse only a correctly rated approved
type should be used and be sure to re-fit the fuse
cover.
IF IN DOUBT — CONSULT A COMPETENT
ELECTRICIAN.
