408-2823
5
of 6
Rev Z
If the crimping chambers conform to the crimping
chamber inspection, the tool is considered
dimensionally correct, and should be lubricated with a
THIN coat of any good SAE 20 motor oil. If not, return
the tool for further evaluation and repair. Refer to
Section 6, REPLACEMENT AND REPAIR.
6. REVISING OLD TOOLS TO SINGLE RATCHET PAWL
Use retrofit kit 2119486-1 for old revision tools with
stamped frames. Use retrofit kit 2119486-2 for old
revision tools with solid frames. Reference Instruction
Sheet 408-10339.
7. REPLACEMENT AND REPAIR
Customer-replaceable parts are listed in Figure 6. A
complete inventory should be stocked and controlled
to prevent lost time when replacement of parts is
necessary. Parts other than those listed should be
replaced to ensure quality and reliability. Order
replacement parts through your TE Connectivity
Representative, or call 1-800-526-5142, or send a
facsimile of your purchase order to 717-986-7605, or
write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For customer repair service, please contact a TE
Representative at 1-800-526-5136.
8. REVISION SUMMARY
•
Updated document to corporate requirements
•
Updated table in Figure 6
Figure 6 (Cont’d)
11
12
20
20
11
12 20
20