408-35043
Rev
D
26
of 30
6.6.
Repairing the adjustable crimp height
Replacing the detent plate
Under severe long-term use, the detent plate can become worn. This makes it difficult to feel the
increments of adjustment. To replace the detent plate, complete the following steps.
1. Note the number indicated on the wire crimp disc (Figure 21).
Figure 21: Replacing the detent plate
1
Atlantic
5
Detent plate
2
Pacific
6
Wire crimp disc
3
Head assembly
7
Ram
4
Crimp height adjustment head
2. Turn the disc to 0 (zero), against the ring stop (Figure 13).
3. Measure the setup dimension from the crimp height adjustment head to the crimper seating
feature on the ram (see Figure 14).
NOTE
The factory setting is listed on the applicator print.
4. While depressing the detent pin, rotate the adjustment head clockwise.
5. Remove all three M3 flat-head screws from the disc.
6. Separate the disc from the head.
