409-10095
Rev
H
11
of 12
7.1.
Daily Maintenance
Perform the following maintenance on a daily basis:
1. Inspect the dies for wear or damage such as cracks, gouges, or chips.
2. Inspect the tool for damage or leaks. If damage is detected, return the tool to TE for repair.
3. Clean the tool, removing accumulations of dirt and grease on the head, particularly in areas where
dies are installed and terminals are crimped. Wipe the entire tool frequently with a clean, lint-free
cloth.
4. Inspect the hydraulic hose and protective braided cover for signs of damage. If either appears loose,
worn, cut, cracked, kinked, indented, pinched, pierced, burnt, partially dissolved, leaking or any other
signs of damage are found DO NOT USE the tool. Serious injury to the user from oil injection may
result. Remove the battery and return the unit to TE for service.
NOTE
BE SURE to return the tool to TE prior to the date indicated on the hose assembly for compulsory replacement of the hydraulic
hose per CE requirements. Refer to the information provided in Section 9 to arrange the return of the tool.
5. Inspect the battery for signs of damage. If found damaged or leaking DO NOT USE. Properly dispose
of the battery. If liquid from the battery comes in contact with a user, flush with water and seek medical
attention as appropriate.
6. If the optional AC power adapter is used, inspect the adapter power cord. If damaged, replace the
adapter.
7.2.
Yearly Maintenance
Once a year, or every 10,000 cycles (whichever comes first) The Electro-Hydraulic Hand Tool should be
returned to TE for inspection. Refer to Section 8 for the return address.
7.3.
General Notes
NOTE
The tool is factory calibrated for the output force.
NOTE
The tool is NOT intended to be field serviceable. Return the tool to TE for service.
NOTE
The tool contains a •voltage cut-off." That is, the tool will not slow down like similar battery powered tools when the battery
charge gets low. Instead, when the battery reaches a pre-determined threshold value, the tool will shut down, indicating the
battery needs to be charged.
8.
RETURN/REPAIR
Order replacement parts through your TE Representative, or call 1.800.522.6752; or write to:
CUSTOMER SERVICE (38-35)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For a list of recommended spares, refer to Figure 5.
TE PART NUMBER
DESCRIPTION
2031495-1
Reset Tool
2031440-1
Rechargeable Battery
Figure 5
