409- 10053
Rev H
6
of 8
3.1. Installation of SDE Crimp Dies
These instructions are specific to the use of TE SDE Crimp Dies. Be Sure to use ONLY TE Crimp Dies.
Installation of Shouldered Dies
(Figure 2 )
1. Remove the battery from the tool.
2. Remove the two die retaining screws from the crimp head.
3. Place the upper die in the upper jaw of the tool head so that the largest indenter is facing inward.
4. Insert the die retaining screw through the upper jaw and through the die. Tighten the screw
just
enough
to hold the die in place. Do
NOT
tighten the screw completely at this time. See Figure 2.
5. Place the lower die in the moving jaw of the crimp head so that the largest anvil is facing inward.
6. Insert the die retaining screw through the lower jaw and through the die. Tighten the screw
just
enough
to hold the die in place. Do
NOT
tighten the screw completely at this time.
7. Replace the battery and pulse the trigger to slowly close the crimp head, making sure the anvils and
indenters are properly aligned.
8. When the anvils and indenters are aligned, tighten the retaining screws.
Figure 2
Upper Jaw
Upper SDE Die
Upper Die
Retaining
Screw
Lower SDE Die
Moving Jaw
Lower Die Retaining Screw
3.2. Removal of Shouldered Dies
To avoid personal injury, remove the battery before removing the dies.
To remove dies from the crimp head, remove the die retaining screws and slide the dies out of the crimp head.
CAUTION
!
DANGER
