409- 10053
Rev H
5
of 8
1. INTRODUCTION
SDE Battery Powered Crimp Tool Kit 1725837--[ ] consists of the SDE Battery Powered Crimp Tool 1725838--1,
as well as two rechargeable battery cartridges (1725839--1) to power the tool used to terminate terminals to
wire. See Figure 1. Each kit has a battery charger. The battery charger part number, its voltage, and the kit’s
region of use are listed in the table below. A battery tool may have a release switch to retract the ram as listed
in the table below. The SDE Battery Powered Crimp Tool is designed to accept interchangeable die assemblies
used in PRO--CRIMPER* Hand Tools for crimping various types of connectors.
BATTERY TOOL KIT
REGION OF USE
BATTERY CHARGER
BATTERY CHARGER
VOLTAGE
RAM RETRACT
SWITCH
1725837--1
North America
1725840--1
110 V
Yes
1725837--2
Europe
1725840--2
220 V
Yes
1725837--3
North America
1725840--1
110 V
No
1725837--4
Europe
1725840--2
220 V
No
1725837--5
United Kingdom
1725840--3
220 V
Yes
2. RECEIVING/INSPECTION
SDE Battery Powered Crimp Tool Kit 1725837--[ ] is thoroughly inspected during and after assembly. Prior to
packaging and shipping, a final series of tests and inspections is made to ensure proper function of the tool.
The following inspection should be performed as a safeguard against potential problems generated in transit.
1. In a well--lighted area, carefully uncrate the tool and inspect each component as it is removed from
the crate.
2. Thoroughly inspect each component for evidence of damage that may have occurred in transit. If any
of the components are damaged, file a claim against the carrier and notify TE Connectivity immediately.
3. Keep this manual and all drawings and product samples with the tool for the benefit of operation and
maintenance personnel.
The crimp tool should be inspected at regularly scheduled intervals, depending on care, degree of operator
skill, the type and size of product being crimped, and environmental conditions.
At a minimum, the tool should be inspected after every 40 hours of use.
3. INSTALLATION/REMOVAL OF SDE CRIMP DIES
Do not operate the tool without the SDE Crimp Head Installed. Damage to the ram or seals can result.
Do not operate the tool without the SDE dies. Damage to the crimp head can result.
The SDE Battery Powered Crimp Tool comes with the crimp head already installed on the battery--powered
hand tool. The only installation required is the installation of the SDE dies.
To avoid personal injury, be sure to exercise extreme caution when handling the crimp tool. Remove the battery before
installing or removing crimp dies.
CAUTION
!
CAUTION
!
DANGER
