TE Connectivity T2212, Руководство оператора

Страница: 15 / 16

15 5 Cleaning and Replacing the Blades
9
10
11
5
8
7
8
7
5
6
13 12
Figure 5 Replacing the Blades Figure 6 Springs
4. If the blades are very dirty with residues of adhesive or if they are worn,
change blades:

Turn the shaft (6) clockwise using a torx wrench TX10 until the gear
racks (7) cannot engage anymore.

Pull the upper blade (9) out of the guides (8).

Take out the lower blade (10).

Remove deposits on the blades with label remover and a soft cloth.

If necessary, replace the blades.

Push the lower blade down into the guides (11).

If necessary, put the springs (12) back into the spring retainers (13).

To re-mount the upper blade push the lower blade down on the cover
and push the upper blade into the guide until the gear racks (7) can
engage with the gear wheels (5).

Turn the shaft (6) counterclockwise using a torx wrench TX10 until the
blade reaches the upper limit.
5. Fit the blade unit (3) according to Fig. 4 into the axes (2) and fold it
towards the cover (4) until it snaps in.
6. Gently push the perforator unit onto the printer.