TE Connectivity T200 IDENT, Руководство пользователя

Страница: 29 / 45

2. PRINTER SETUP ENGLISH VERSION
2-19
2.9 Media Sensor Calibration, Self Print Test, and Dump Mode Utilities
The test print contents should be changed by the following commands
and parameters:
2.9.2 Self Print Test and
Dump Mode (Cont.)
PROGRAM VERSION: VX.XX XXXX --- Firmware version and checksum
TONE ADJUST: +XX---------------------------Print tone fine adjustment value
FEED ADJUST: +XX.Xmm------------------------ Print position fine adjustment value
CUT POSITION ADJUST: +XX.Xmm ---------Cut position fine adjustment value
BACKFEED ADJUST: +XX.Xmm--------------Back feed amount fine adjustment value
PARAMETER: [PC-850][0]---------------------Character code selection and Font “0”
selection
[9600] [8][1][NONE] [2] -----Baud rate, Data length, Stop bit length,
Parity, and Transmission control of RS232C
[ON] [AUTO] [FEED][B0]--------Forward feed wait function, Control code,
Feed key function, and Euro code
X-COORDINTE ADJUST: +XX.Xmm--------- X-coordinate fine adjustment value
SENSOR SELECTION: TRANSMISSIVE- Sensor selection and sensitivity
SENSOR ADJ. VALUE:
TRANSMISSIVE[XX] REFLECTIVE[XX]
---- Sensor setting value
PRINT SPEED: 5IPS----------------------------------Print Speed
FLASH ROM:4MB -------------------------------Flash ROM Capacity
SDRAM: 8MB--------------------------------------SDRAM Capacity
USER MEMORY: [X KB] [0 KB]-----------------User Memory Capacity
TTF AREA: [XXXKB] [XXXKB] ----------------True type font storage area, Main PC board
and optional memory card
EXT CHAR AREA: [XXXKB] [XXXKB] -------Writable character storage area, Main PC
board and optional memory card
BASIC AREA: [XXXKB][XXXKB] -----------BASIC file storage area, Main PC board and
optional memory card
PC SAVE AREA: [XXXKB][XXXKB] -------PC save storage area, Main PC board and
optional memory card
INFORMATION:---------------------------------Printed only when some information is
stored in the flash ROM
TOTAL FEED------------------------------------- Total feed distance
TOTAL PRINT: 0.00 km-----------------------------Total Print distance
TOTAL CUT: 0 ------------------------------------Total Cut Count
IP ADDRESS: 192.168.10.20 -----------------
SUBNET MASK: 255.255.255.0-------------
GATEWAY: 0.0.0.0-----------------------------
MAC ADDRESS: XX-XX-XX-XX-XX --
DHCP: Disabled----------------------------------
DHCP CLIENT ID:
FFFFFFFFFFFFFFFFFFFF FFFFFFFFFFFF -----
SOCKET COMM.: Enabled-------------------
SOCKET COMM. PORT: 08000--------------
Network setting values