Tyco Electronics Corporation
300 Constitutional Drive
Menlo Park, CA 94025 USA
No: RPIP-824-00
Rev: F
Date: April 28, 2006
Page: 11 of 11
© 2005-2006 Tyco Electronics Corporation. All rights reserved.
Unless otherwise specified dimensions are in millimeters [Inches dimensions are in between brackets]
If this document is printed it becomes uncontrolled. Check for the latest revision.
4.5.3 Inspection
1.
Positioning: Wires stripped 8.0 [0.315] should overlap each other at least 6.5 [0.250].
2.
Heating: The solder ring shape should not be visible and a solder fillet, at least 4.5 [0.180]
long, should be visible on one side of the leads.
3.
Damage: The sleeve should not be split or cut and no wire strands should poke through the
sleeve. Fillet length should be 8.0 [0.315] for 12.5 [0.500] stripped wires.
Unacceptable:
Insufficient heat.
Contour of solder perform is visible.
Acceptable:
Solder has lost all appearance of ring shape.
There is a definite fillet visible along the wire interface.
DISCLAIMER
All of the above information, including illustrations, is believed to be reliable. Users, however, should independently evaluate the suitability of each product
for their application. Tyco Electronics makes no warranties as to the accuracy or completeness of the information, and disclaims any liability regarding its use.
Tyco Electronics' only obligations are those in the Standard Terms and Conditions of Sale for this product, and in no case will Tyco Electronics be liable for
any incidental, indirect, or consequential damages arising from the sale, resale, use or misuse of the product.
