409-35018
Rev A
13
of 15
3. Use the gage to check the opening between the indenters (Figure 9) to determine if the die
assembly is to the correct dimension.
The GO gage should enter freely. A snug fit is acceptable. If the go gage does not enter freely
into the die, check to see that you have the correct go/no-go gage.
The NO-GO gage should not enter. If the no-go gage enters freely into the die, this indicates
wear to the indenters, or (less probable) wear to the drive arms. Confirm that the tool is within
specification (see section 4).
NOTE
The indenters are manufactured using S-7 tool steel, and are heat treated to Rc 56-58. As a result, they have a life expectancy
of many thousand cycles. Indenters are available for purchase separately from a die assembly. Contact the factory for details.
CAUTION
Do not crimp against a gage. To do so damages the tool and voids the warranty.
Figure 9: Location of GO/NO-GO gage
