408-9279
Rev F
6
of 7
3. Align the NO-GO element and try to insert it straight into the same crimping chamber. The NO-GO
element may start entry but must not pass completely through, as shown in Figure 6.
Figure 6
If the crimping chamber conforms to the gage inspection, the dies are considered dimensionally correct and
should be lubricated with a THIN coat of SAE 20 motor oil. If not, the dies must be repaired before returning
them to service.
For additional information concerning the use of a plug gage, refer to Instruction Sheet
REPLACEMENT AND REPAIR
The parts listed in Figure 7 are customer-replaceable. A complete inventory can be stocked and controlled to
prevent lost time when replacement of parts is necessary. Order replacement parts through your TE
Representative, or call 1-800-526-5142, or send a facsimile of your purchase order to 1-717-986-7605, or write
to:
CUSTOMER SERVICE (038-035)
TE CONNECTIVITY CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
Dies may be returned to TE for evaluation and repair. For tool repair service, contact a TE Representative at
1-800-526-5136.
Item No.
Part Number
Description
Qty Per Die
1
3-21000-4
Screw, Skt Hd Cap, 10-32 x .375 In. L
1
2 (Not Shown)
21027-3
Wrench, Hex, L-Handle, .050 In.
1
3
21061-1
Screw, Set, Skt, Cone PNT #4-40X, 12
1
Figure 7
