408-10380
3
of 3
Rev
C
4. Center the seating tool (with the cage
assembly) under the ram of the application tool.
Slowly lower the ram until it just meets the
seating tool. Verify alignment of pc board
support, pc board, cage assembly, and seating
tool.
Damage to the pc board, seating tool, or cage
assembly may occur if the seating tool is not
properly seated on the cage assembly before
cycling the application tool.
5. Cycle the application tool to seat the cage
assembly on the pc board. Then retract the ram,
and carefully remove the seating tool by pulling it
straight from the cage assembly.
6. Check the cage assembly for proper seating
according to the following:
a.the widest section of each compliant pin is
inside its intended pc board hole
b.each alignment post is in its intended pc
board hole
c.if present, the gap between the standoffs
and the pc board is no more than 0.10 mm.
For detailed application requirements of the cage
assembly, refer to the application specification
given in Figure 1.
6. MAINTENANCE AND INSPECTION
The seating tool kit is assembled and inspected
before shipment. It is recommended that the seating
tool kit be inspected immediately upon arrival at your
facility to ensure that it has not been damaged during
shipment, and that it conforms to the dimensions
provided in Figure 3.
6.1. Daily Maintenance
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and contaminants
with a clean, soft brush or a lint-free cloth. DO
NOT use objects that could damage the
components.
2. When the seating tool and wall support are
not in use, store them in a clean, dry area.
6.2. Periodic Inspection
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the seating tool or be supplied to
personnel responsible for the seating tool kit.
Inspection frequency should be based on amount of
use, working conditions, operator training and skill,
and established standards.
7. REVISION SUMMARY
•
Added table to Figure 2
•
Changed dimension in Figure 3
Figure 3
CAUTION
!
NOTE
i
1.375 ±0.013
34 ±0.4
28.15 ±0.4
33 ±0.4
