408-2349
4
of 5
Rev
E
Figure 6
3. Using a crimp height comparator, measure the
braid, insulation, and seal sections of the ferrule,
and the center contact crimp. Avoid measuring over
any ridges. If the crimp height conforms to that
dimension, the tool is considered dimensionally
correct. If not, refer to Section 5 for information on
obtaining customer repair service.
For additional information concerning the use of a plug
gage or crimp height comparator, refer to instruction
sheet 408-7424.
5. REPLACEMENT AND REPAIR
Customer-replaceable parts are listed in Figure 7. A
complete inventory should be stocked and controlled
to prevent lost time when replacement of parts is
necessary. Parts other than those listed should be
replaced to ensure quality and reliability. Order
replacement parts through your representative, or call
1-800-526-5142, or send a facsimile of your purchase
order to 717-986-7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For customer repair service, please contact a
representative at 1-800-526-5136.
6. REVISION SUMMARY
Since the last revision of this document, the following
changes were made:
•
Updated document to corporate requirements
•
Corrected trademark references
HAND
TOOL
APPLIED
PART
NUMBER
CABLE
TYPE
CRIMP HEIGHT DIMENSION
“A”
Center Contact
“B”
Braid
“C”
Insulation
“D”
Seal
69376
2-330953-2
RG-142A
RG-142B
Use Plug Gage
(Refer to Paragraph 4.3.C)
5.36-5.61
[.211-.221]
5.68-6.05
[.224-.238]
7.87-8.46
[.310-.333]
69376-2
131223-2
131228-1
RG-400
1.91-2.01 [.075-.079]
69376-1
330884
330953
RG-58A
RG-58C
Use Plug Gage
(Refer to Paragraph 4.3.C
4.95-5.21
[.195-.205
5.31-5.66
[.209-.223]
69376-3
330953
330884
RG-58
RG-58B
1.91-2.01
[.075-.079]
Position Point on
Most Compressed
Area
Modified
Anvil
Crimp Height
A
B
C
D
