408-35143
Rev A
4
of 7
3.2.
Pinned dies
1. Install the wire and insulation anvil dies with the chamfers facing the front of the tool and the die
markings facing outward into the movable jaw of the tool frame (Figure 3).
2. Insert the die retaining pins and the short die retention screw. Do not tighten the screw completely.
3. Install the wire and insulation crimper dies with the chamfers facing the front of the tool and the die
markings facing outward into the stationary jaw of the tool frame.
4. Insert the die retaining pins and the long die retention screw. Do not tighten the screw completely.
5. Slowly close the tool handles, allowing the dies to mate or align. Continue closing the tool handles
until the ratchet makes the seventh click.
6. Tighten both die retention screws until snug.
NOTE
The tool ratchet has detents that click eight times as the handles are closed. The ratchet releases on the eighth click.
7. Install the locator assembly and tighten the hex nut.
Reverse these steps to remove the die assembly.
Figure 3: Pinned dies
1
Anvil dies
5
Locator
2
Chamfers
6
Tool frame
3
Crimper dies
7
Die retention screws
4
Nut
8
Die retention pins
