409-35009
Rev E
32 of 44
10. Unscrew the cable gland (Figure 24), using care not to damage the existing wire going through it.
11. Route the air feed cable through the cable gland into the electrical box.
12. Plug the air feed cable into connector J17 on the PC board.
13. Retighten the cable gland securing the air feed cable. Use care not to overtighten and damage the
wire.
14. Reverse steps 2 and 3 to reassemble the guards.
15. Install the air feed applicator onto the baseplate and connect it to the applicable ports.
16. Make sure the slide valve is off (pulled away from the filter).
17. Install a (customer-supplied) hose fitting in the shut off valve.
18. Attach the air supply hose to the air valve assembly.
19. To turn air on, rotate the shutoff valve to ON. To turn air off, rotate the shutoff valve in the opposite
direction.
20. To lock air in the OFF position, rotate the shut off valve to the OFF position and secure the lockout with
a (customer supplied) padlock.
NOTE
The air can be turned OFF by rotating the shutoff valve to the OFF position.
NOTE
The return feed stroke for the two fastest machine speeds occurs 220 milliseconds after the start of the crimp cycle. For the
four slower machine speeds, it occurs 440 milliseconds after the start of the crimp cycle.
