TE Connectivity 220015 Series, Инструкция

Страница: 1 / 6

©2012 Tyco Electronics Corporation, a TE Connectivity Ltd. company
All Rights Reserved
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or company names may be trademarks of their respective owners.
1 of 6
Instruction Sheet
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
408-2331
Heavy Head Hand Crimping
Tools (HHHT) 220015-[ ]
19 APR 12 Rev C
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Figure 1
1. INTRODUCTION
This instruction sheet covers application and
maintenance procedures for Heavy Head Hand
Crimping Tools 220015-[ ]. Refer to Figure 1. The hand
tools are used to crimp a variety of coaxial connectors
with flexible cable. For applicable connector part
numbers and corresponding cable sizes, refer to
Catalog 1307191. Information pertaining to the
connectors (cable stripping dimensions and assembly
of component parts) is included in instructions
packaged with the connectors. Read all instructions
thoroughly before proceeding.
Dimensions on this sheet are in metric units
[followed by U.S. customary units in brackets].
Figures and illustrations are for identification only
and are not drawn to scale.
Reasons for reissue are provided in Section 6,
REVISION SUMMARY.
2. DESCRIPTION
Each tool features integral dies that have two crimping
areas (one to crimp the center contact, and one to
crimp the ferrule), an adjustment cap that rotates the
locator-stop (as required), and a CERTI-CRIMP hand
crimping tool ratchet control which ensures full
crimping. Once engaged, the ratchet will not release
until the tool handles have been FULLY closed.
The FRONT of the tool is marked with the part
number. The center contact enters the crimping area
from the RIGHT side of the tool. The contact/cable
assembly is inserted through the BACK of the tool for
ferrule crimping.
3. ASSEMBLY AND CRIMPING PROCEDURES
Select the appropriate cable and connector for the
tool. Slip ferrule over cable; then strip cable to the
proper length, according to instructions packaged with
the connector (plug or jack).
3.1. Crimping the Center Contact
Refer to Figure 2 and proceed as follows:
1. Determine contact type (long or short) from the
dimensions provided in Figure 2. Rotate locator/
stop by turning adjustment cap to OPEN position for
long-type contacts, or CLOSED position for short-
type contacts.
Adjustment Cap
CERTI-CRIMP*
Hand Crimping Tool
Ratchet Control
Integral Crimping Dies
Center Contact
Crimping Area
Ferrule
Crimping Area
Front of Tool
Right Side
of Tool
NOTE
i
O
R
IG
INAL
INST
RUCTIONS