TDW POLYSTOPP, Инструкция по эксплуатации и обслуживанию

Страница: 5 / 52

TDW France-22-E-03-09
5
Section I: Introduction
1.0 Description
The POLYSTOPP
®
Tapping and Plugging
System is designed for use on 315 and 355 mm
polyethylene pipe.
The system is designed for use with TDW
Electrofusion Saddle Fittings. The fittings
permit access to a line to plug it while line work
is being performed.
The entire system includes equipment for
tapping into the line, plugging the main, and
installing a completion plug in the fitting in order
to remove the tapping valve. Some components
of the 315-355 mm system are shown in Figure
1.
Tapping Plugging Completion
Figure 1. POLYSTOPP

System big sizes
for PE Pipe 315-355 mm
This manual describes the procedures for using
this tapping, plugging and completion system to:
•
plug the main line, keeping the line in
service.
•
to complete the job by setting a
completion plug, enabling removal of
all tapping/plugging equipment.