18
Troubleshooting
Problem/Issue
Cause
Soluction
1
Cannot bind drone to
controller
a) Battery
b) Electromagnetic interference
c) Out of range
a) Make sure the batteries in both drone and
controller are fully charged
b) Clear out objects between drone and controller
c) Put drone and controller closer to each other
2 Drone does not turn on
a) Battery too low
b) Battery not fully plugged in
a) Charge battery
b) Battery fully plugged in the correct direction
3 Controller does not turn on
a) Switch didn't turn on
b) Battery didn't install correctly
c) Battery power too low
a) Ensure switch is turned on
b) Ensure battery fully plugged in correctly and
securely
C) Charge the battery
4
Blades do not spin or
drone has difficulty taking
off the ground, LEDs are
flashing
Battery power level is too low
Fully recharge the battery
5
Unstable drone flying /
strong vibration
a) Damaged blade(s)
b) Gyroscope needs calibration
a) Replace the blade(s)
b) Calibrate the gryoscope (page 15)
6
All blades spin but drone
does not take off the
ground or not flying
properly
Blades are not installed correctly
Reinstall the blades following the "Blade
Installation" section on page 14
7
Drone crashes
immediately
Blades are not installed correctly
Reinstall the blades following the "Blade
Installation" section on page 14
8
Drone can not perform
360°/180° Roll
Battery power level is too low
Fully recharge the battery
9
Drone can not perform the
Stunts
Drone is not in 180° Rolling
mode
Short press MFB once switch to 180° Rolling
mode (page 11).