![TDK veloCD ReWRITER Скачать руководство пользователя страница 10](http://html1.mh-extra.com/html/tdk/velocd-rewriter/velocd-rewriter_installation-and-user-manual_3892235010.webp)
DETERMINE YOUR EXISTING IDE CONFIGURATION
With your computer open, determine the existing IDE configuration. You can do this by looking at
the 40-pin IDE ribbon cable (or cables—there may be two) and seeing what is connected to them.
One end of the IDE cable is connected to a port on the computer’s motherboard; and the other end
is connected to one or two peripheral devices (such as a hard drive or CD-ROM drive). If there are
two devices, one is considered the master and one is the slave. If there are two IDE ports, one is for
the primary IDE bus and one is for the secondary bus.
A typical drive’s IDE configuration is usually one of the following:
•
Hard drive connected as master and slave devices on primary IDE port; CD-ROM drive connected
as master device on secondary IDE port.
•
Hard drive connected as master device and CD-ROM drive connected as slave on the primary IDE
port; nothing connected to secondary IDE port.
•
Hard drive connected as master device on primary IDE port; nothing connected to secondary IDE port.
SELECT AN IDE CONFIGURATION
Set the jumper according to the desired configuration, as shown in this table and illustrations.
6
veloCD ReWRITER :
User’s Manual
Hard drive connected as master and slave devices on
primary IDE port; CD-ROM connected as master
device on secondary IDE port.
Hard drive connected as master device and CD-ROM
drive connected as slave on the primary IDE port;
nothing connected to secondary IDE port.
Hard drive connected as master device on primary IDE
port; nothing connected to secondary IDE port.
Connect the veloCD ReWriter as master device to the
secondary IDE port. Remove the CD-ROM drive, change it
to slave, and connect it to the secondary IDE port.
NOTE: With this configuration, it is very difficult to write
from the CD-ROM to the veloCD ReWriter using "on-the-fly"
copying. Use the image writing method for best results.
Connect the veloCD ReWriter as master to secondary IDE port.
Connect the veloCD ReWriter as master to secondary IDE port.
Before veloCD ReWriter Installation
How to Install the veloCD ReWriter
A
B
C
QUICKSTART INSTALLATION-Experienced PC Users Only
If you’ve installed computer peripherals before, use
this quickstart installation designed to get you up
and running quickly. Always turn off and unplug
your PC before you start.
Typical Scenario 1:
You have a PC with an IDE
interface installed, you have Windows 95B/95C/
98/ME/2000 or NT 4.0, and you have nothing
installed on the secondary IDE port.
What to do:
Set the veloCD ReWRITER’s jumper to
Master, attach it to the secondary IDE port, and go.
Windows will recognize the drive automatically.
Typical Scenario 2:
You have a PC with an IDE
interface installed, you have Windows 95B/95C/
98/ME/2000 or NT 4.0, and you have a CD-ROM
installed on the secondary IDE port.
What to do:
Change the CD-ROM to Slave, set the
veloCD ReWRITER’s jumper to Master, attach the
veloCD ReWRITER to the secondary IDE port, and go.
Windows recognizes the new drive automatically.
IF NEITHER OF THESE SITUATIONS APPLIES TO YOU,
OR YOU’RE NOT COMFORTABLE WITH IDE INSTALLATION,
READ THE REST OF THIS CHAPTER FOR MORE
DETAILED INSTALLATION INSTRUCTIONS.