- 3 -
TDK-Lambda
ELC12 Series
INSTRUCTION MANUAL
5. Terminal connecting method
Pay extra attention to the input wiring. Wrong connection may cause damage, electric shock or fire.
Never connect output wire and input wire in reverse.
·
Input must be off when making connections.
Input must be turned on after completing wire connection including LED.
·
Input wire and output wire shall be separated.
·
Take enough consideration to avoid electric shock.
·
Do not subject the unit to scratch and undue stress such as bending or pulling the input and output wires.
·
When connecting wire, connect firmly by ensuring no loose connection, omission, and no wire being pulled out.
·
Input and output wire is not waterproof. If there is risk of contact with water, waterproofing is necessary.
·
Do not connect product output in series and parallel connection.
·
If PSE is needed, connect output line (V-) to ground. In addition, be sure to connect the earthed line of the
input terminal to ground.
Note : This power supply unit is for driving LED loads.
L (Brown)
Load
V- (Black)
V+ (Red)
N (Blue)
Earth (Green / Yellow)
Input (PRI)
Output (SEC)
